Post by lordzorogwolfblood on Jun 12, 2013 7:34:25 GMT -5
Well what happened was while entering on to the floor of Hero Con in Charlotte NC, there were 4 security guards standing at the entrance checking people for weapons. Well when they saw "Xu'kata" clipped to my belt ,with its 3 inch claws that look like I could chop someone in the head,they stopped my and demanded I hand it over to be inspected. So I complied and they deemed it too dangerous to be on the floor, they told me if it was made of plastic then it would be ok. Well I had my other saber from Ultra sabers that I brought in instead and At least got to sport the black blade Lance custom made, and while walking around I saw at least 2 tables , 1 close to each entrance that were covered in Knives and swords. Not just novelty swords, but like cold steel blades. I still scratch my head at that, if I really wanted to maim someone I could have rushed the table and grabbed a machete and gone to town....but whatever, maybe next con
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5