Post by ZahcStarKiller on Jun 30, 2015 1:27:50 GMT -5
This may be what I have been looking for... I am planning a blaster build that uses an actual 2W visible spectrum laser diode. It will burn things and light candles. Already have the hookup on the electronics and it is actually legal. MWAHAHAHA.
Post by Solo's Hold on Jul 1, 2015 20:32:13 GMT -5
I have to take a moment to give a shout out to Lichtbringer of the RPF who went MIA so I am told for about 2 years until recently, he is the one who came up with the idea for the step up spacer for the flashider to adapt to the barrel.
THANKS for all your hard work and innovation, We couldn't have done it without you.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5