Post by IndustrialAction on Aug 4, 2014 8:40:54 GMT -5
Hey all, I am creating this thread as an on-going place that I will update with my status. I want everyone to know that I have all of the PM's that have come in and I will respond as soon as I can. I was out of town last weekend and will be gone again all next week. On top of that, a neighbor appears to have dug where they shouldn't have and cut the Verizon FiOS line to my house. The earliest I'll have service is Wednesday. I will be working off of my phone and iPad until then.
Right now I am finishing up the re-build for jediwizard. Once that is done I can get my SK configured and up for sale and rock out the blades I owe people and a couple of builds.
Benpass - I have your shipping funds but can't create a label until I get internet access restored at the house
I'll update this thread as things change/progress. Thank you for your patience!
Post by IndustrialAction on Aug 6, 2014 12:48:59 GMT -5
jediwizard - your saber is wired and working with a new Igniter Mini. Check out my Facebook page for pics. I just need to wire the main LED and button it up. I won't have time to configure it before I go out of town so I will send back your original SD card and a new one loaded with the config I have on my Starkiller. You'll be able to change your config once you get it. The card is very easy to get to.
Message me with your shipping address. We'll deal with payments once I figure that out later.
benpass - I'll ship your blade when I ship jw's saber since both are international and I'll have to go to the PO to send them
SabreBlade Run Customers - I have payments and will update the list soon. We are getting close to kicking that off
Other Blade customers or others that have PM'd me - I'll be in touch as soon as I can
Post by IndustrialAction on Aug 17, 2014 21:02:13 GMT -5
Ok, I'm back and planning on starting more work on Wednesday. I'll finish up the outstanding blade orders from past customers and get the run list up to date. Ben and Glen's stuff is out. I'll be working on Ed's saber and the config for the TFUII next.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5