If you've always wanted to be a shistavanen, but had no idea where to start, this listing is for you!
I'm selling resin mask blanks to offset some legal bills :(. They are exact copies of the base I used to make my shisty.
Fur as is, or use sculpting materials for a more custom look. I'm happy to point you in the right direction as far as tutorials are concerned :3
This blank was designed for a more realistic look, but could easily go tooney or semi-realistic.
Each blank is cut and hinged, with springs installed. (I am installing springs on this blank after hitting up the hardware store tonight).
Each blank comes with 1 pair of clear resin eye blanks, not installed.
Due to the nature of the casting process I use, each blank is a little different. I personally test each blank to make sure it's going to be comfortable, and works correctly.
These blanks fit several different types of jaw sets from a few different makers, some requiring slight modification. I am unsure about silicone noses, but I see no reason they can't be added. Again, I'm happy to point you in the right direction
If you would like the tear ducts cut, I am happy to do so to accommodate the 1" eye blanks. That being said our faces and characters are all different, thus might require different eyes or tear duct shapes, which is why I'll leave that decision up to you.
Each Blank is $100 plus $14 S&H. I'm happy to make arrangements here or put up an etsy listing.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5