I'm selling my prototype of the Leia rig I did last summer.
The belt is done in Olive Drab Webbing and sized for my waist of 36" but can go bigger and smaller, I'm estimating 3 sizes either way to be safe. It could be made to go much smaller if the webbing itself was cut and shortened. I made this with a fast clip side release buckle in the back and slide adjustments for the sizing, just like a backpack shoulder strap. The front slide buckle is as close to accurate as I could find AND made of heavy metal
The Holster is set up for a accurate size Leia ROTJ Blaster, so that is easy enough.
I'm asking for $75 plus shipping for this as is. If you want a set of the 4 pouches I did, I can make those for you for an additional $75.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5