I heard you guys like teasers, So here is a taste of things to come!
I'm about to post some pics of the latest Force Witch I've completed and realized I still needed to update this. I've been quite busy with things and neglected to follow up on this. you've seen em before but I wanted to add a few more pics from the photo shoot.
The alignment of the blades in this last pick look a little off, it's just a trick of the camera and angle. In staff mode the blades are perfectly square with eachother, no so easy, considering the curvature of the hilt and coupler. Quite the little engineering feat.
Last Edit: Jul 21, 2015 15:09:06 GMT -5 by Obi-Shane
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5