This time around I thought I would show you all the before and after pics of a set of Solo's Hold Force Witches. Mind you they have already been finished and polished at this point. But the main focus of these pics was to show the before and after effects of the hand painting. They are done using small paint brushes, a couple of glasses of wine ( I mean sparkling cider ), and more than a few hours. I wanted you guys to see what I see before the final step. These hilts are completely installed and ready to go, minus the painting.
After: Coming very soon, I need to edit them/watermark and upload them.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5