Post by chancellor on May 27, 2012 20:08:14 GMT -5
I must apologize for the delays. I was sick the whole winter and had a terrible flu that lasted 2-3 months just a while ago. I had zero energy and now I'm finally getting better. So next I'll start bringing the old reviews from the past and start writing new ones. Like for example EFX Luke reveal lightsaber review. If possible, I prefer now Niko instead of Chancellor
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5