Post by Rogue Five on Mar 12, 2016 20:54:06 GMT -5
Damn. Didn't notice this run stopped at 30 spots. I was on the fence about it but now seeing that it's limited and is going to have serial #'s makes me wish I had jumped on board. You guys made the right choice. It'll be epic.
I swear if my wallet could survive it, I'd buy everything Solo's Hold makes.
Last Edit: Mar 12, 2016 20:54:40 GMT -5 by Rogue Five
Still needing to raise funds for other stuff. Had hoped to have sold one of my other sabers to get enough to put a deposit down. I will have to relinquish my spot unfortunately. This run is going to be awesome.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5