Woodchuck here. I just finished a run of these long rifles. They are used by sand troopers, and are affectionally known as the 'BFG". Big F------- Gun. T-21 is the designation. My version is made from wood and PVC. It is 53 inches long, weighs in at 4 1/2 pounds.
Amazing work, this blaster and your other stuff as well, woodchuck!
Interestingly, my family is full of carpenters, joiners and woodworkers (come to think of it, my other grandfather ran a sawmill), so even though I'm personally not that much into woodworking, I have a soft spot for it!
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5