Is this going to have the triangle ring? Looks like it's 90 degrees from the button in the animation methos provided...
Speaking of which, they haven't come out with a new Star Wars Black Series 6" Ezra Bridger figure with updated accurate season 3 lightsaber. I'm going to go harass Hasbro now and see where that gets me...
I hope you guys can make Kanan's saber a two-parter just like in Rebels. Put me down for the pair either way! Thank you.
From an earlier post on Page 5:
Customer: will the blind knights emitter detach like in the show? when do you think you'll start taking payment? its hard for me around this time of the year and need to time my purchases
Obi-Shane: Yes, it will detach.
When Aaron opens up the official run. What will happen is that aaron will take over this thread and moderate it and then payments will be listed and updated. Don't worry, you wont miss then run if you check back in here at least once a week.
I will be updating the list again this weekend. But wanted to say that some new stuff has been released that will have us modify the files on the Orphan a bit. Mainly the grenade. Blame the animators for this. lol.
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5