Up for sale is my prized saber but alas I need to fund another project. Asking price is $625 $600$550$500 $450 $425 Shipped continental (was $650 + Shipping)(last price drop before heading to Ebay-Now listed on Ebay but would rather sell here) US and Paypal only(Friends and Family).Today Only in Honor of May the 4th pricing of $425 shipped and Insured Will consider International if buyer pays shipping. It is an MHS Luke V2 Clean. Ran on a Crystal Focus 5.06 with the following features: -Powerdercoated by TCSS -Built By MH/Chewbacca of FX Sabers -GGW Tri Cree with White COF w Quick Disconnects for easy swapping of LEDs -Touchplate activation auxiliary switch( for Blaster Block , Lockup and to choose sound bamks) -External recharge port in Pommel w Kill key -Access to SD card by Removal of Pommel and sliding Speaker out -7.4 V 3100 MAH Lithium Ion Pack(2 x Panasonic 18650s, Nice long Run Time) -2 Watt 8 ohm High Power 28 MM Speaker(Very Loud)- 6 sound fonts -Novastar, EpII, Shatterpoint, Ancient Saber, EP IV, Fates -Sabertracks -Green and Red accent Leds in the clamp(Main Switch Under Lever) -Accurate card cone Knob and lever by Pastor Jedi - Also included is a RRW Rebel w QD and a BBW Rebel w QD Includes Blade Plug, Saber Stand and kill key. No Charger(Will take 7.4 V Li-ion with 2.1 MM Plug) or Blade. Will provide one for $25 each. This saber has been my "shelf Queen" no Dueling but definately duel worthy, Kept in a smoke Free Home . Please feel free to PM me with Questions or Offers Last photo showing how to swap LEDs...
Last Edit: May 13, 2017 20:50:29 GMT -5 by jedibowls
profezzorn: hey ARKM, did you ever write a that tutorial on the toner transfer method?
Jun 23, 2017 15:50:15 GMT -5
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5