Post by Darth Midian on Dec 15, 2011 18:56:44 GMT -5
I was contacted by a woman on Facebook who is going to Mega-Con. One her costumes is a Sith Cheerleader. She had ask me if I could build hilts for her floggers. I told her as long as the handles are the right size it shouldn't be a problem. The handles are 3/4". They were perfect. 1st I had to remove the braids from the handles.
The handles fit perfectly inside some scrap 1" thick walled blade stock.
Then I slid the flogger/bladestock set up inside 1" pvc.
ARKM: *waves hand* "I'm not the slacker you're looking for"
Jun 23, 2017 16:24:16 GMT -5
ARKM: Sadly no. Well, that's not entirely true. I did finish writing it but did not perform the steps and take pics of said steps.
Jun 23, 2017 16:26:30 GMT -5
ARKM: So it's like "Step 5: Using the high temperature temp, tape the paper with the design on it onto the metal part to be etched."
Jun 23, 2017 16:26:53 GMT -5
ARKM: ... but there's no Pic 4.
Jun 23, 2017 16:27:10 GMT -5
profezzorn: from other things I've read it's just PNP blue with some heat and pressure applied, right?
Jun 23, 2017 16:37:26 GMT -5
ARKM: Some use that. I could not get successful results with it but others have.
Jun 23, 2017 16:47:16 GMT -5
profezzorn: so what do you use?
Jun 23, 2017 16:47:36 GMT -5
ARKM: I personally use glossy magazine pages. I just rip a page out of a magazine and put it in the printer. The pages have to be the right thickness for the printer though. Too thin and they rip in the printer.
Jun 23, 2017 16:47:42 GMT -5