Post by Darth Midian on Dec 15, 2011 19:17:57 GMT -5
I finally finished my rendition of Darth Nihl's saber. I was going for a bio-organic/mechanical feel with this piece. I also installed the activation switch off center; in my mind a gnarly looking hilt like this would not have a centered anything. The total length of this beast is 61.5" (5'-1.5"). The blade is 27.5" and the hilt is about 34". This saber features: All custom PVC hilt, 1"thick walled trans white blade, Lux III red orange led with resistor, 5 degree lens, Obi Wan econo board, orange ring illuminated switch, a single 14500, 3.7V Li-ion TCSS premium speaker, and recharge port. This thing is as tall as my 10 year old daughter.
Thanks Jammo. This saber is pretty cool. I remember when I first saw the picture of Darth Nihl holding this saber. I was in awe, I instantly fell in love with this saber and started brainstorming ways I could build it.
megtoothsith: clamp card switch solution on Korbanth MPP, channel the core to the LED Module and run switch wires alongside LED? or Channel core just forward of the threads perpendicular to the existing channel topside?
Aug 15, 2017 8:56:46 GMT -5
jedicri: thanks ARKM!
Aug 15, 2017 14:29:10 GMT -5